Excellent
What's the speed..What made you decide to buy?
Takekawa:Change to a TAF 5-speed Close Ratio Transmission Kit, and visually I bought it because I wanted to check the shift position and the GROM It would have been nice to be able to check the Shift position in the OEMMeter, but.. I guess they didn't adopt it because of the Cost (tears)
In the case of OEMGEAR and TAF 5-speed Close Ratio Transmission Kit Likewise, I'm going to do a phantom TopGear changing (sweat) Protec:SPI- After installing the M10 Shift position Indicator, the phantom Top gear is gone
How was your experience with it?
When GEARUp/Down, it is not displayed immediately It is displayed after a little delay The place where Neutral is displayed as 0 is a regrettable place I don't want to worry about it because I only use it........ If it's not OEMSprocket, initial learning is required, except for OEMGEAR and No initial training is required for the OEMSprocketSpec By the way, if you need a Shift Up Indicator, you can use OEMGEAR and OEMSprocket MyGROM can be used as it is if it is not necessary though it is necessary to set also Both Sprocket and GEAR have been replaced, so an initial learning curve was necessary Initial learning can be done on a real run or on Maintenance Stand I used the maintenance stand to do the initial learning I used the maintenance stand to do the initial learning while watching the meter If you have a Course, you can do the actual run
Was the installation difficult?
To install it, remove the OEM meter and connect it to the OEMConnector You only need to insert the Harness Because the power supply and the Earth connection are not necessary, it is a pompous installation However, because it has to do waterproof processing, that is a Large strange place, but The Instruction Manual for Handling describes it in detail, so take your time I think you can't go wrong if you hang it up and work with it Also, the Harness for car models has a 12V service terminal I connected the power line of KOSO Mini3Digital A/F ratio meter to this terminal
【Please tell me the installation point and hang】
Since the OEMConnector is interrupted by the vehicle-specific Harness, the Light It's a matter of putting the Wiring together well Also, Waterproof treatment is a spec. to put the attached Seat As I mentioned before, you should work slowly and without haste However, the Construction Manual provides details, so please take the time to review it Please
[Was the Instruction Manual easy to understand?
The initial learning content is described in this manual, which is difficult to understand after just one look at it You can learn the initial study over and over again, even if you get it wrong, so when you do, the Instruction Manual to review and relearn Once you've successfully completed your learning, the Instruction Manual is easy to understand! That's what I mean
[Included Parts:were they on?
Comes with Bar Handlebar Bracket and Double-sided Tape Compatible Handlebar Diameter of the Bar Handlebar Bracket:22.2mm/1 Inch (up to Large35mm) Double-sided tape can be used after the initial learning is completed if the initial learning is required On the back of the Indicator there is a Switch that is required for initial training If the initial training fails, you will have to remove the double-sided tape in order to re-learn it Note that it is notView Detail